Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Mode 09 - Read Vehicle Information
Diagnostic Mode 09 makes it possible to access vehicle-specific information from the ECM and the TCM (where applicable).
Depending on scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.
Test requirement
- No DTCs stored in the DTC memory.
Procedure
-- Connect the scan tool.
-- Switch the ignition on.
-- Select "Diagnostic Mode 09 - Vehicle Information".
-- Select the desired "Test-ID".
-- The information requested will be displayed on the scan tool screen.
The following table is a numerical list of all "Test-IDs" that may be selected.
| Test-ID | Diagnostic text |
|---|---|
| 02: | Vehicle identification number e.g. |
|
|
| 04: | Calibration identification e.g. |
|
|
|
|
| 06: | CVN (check sum) e.g. |
|
|
|
-- Switch the ignition off.
End of Procedure
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.