Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
OBDMID Test-ID 61 ($3D): Tank Vent Valve - Function Check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored".
Select "OBDMID 61 ($3D)".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test ID (Hex-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 128 ($80) | P0441 | Purge Flow Monitor. | 0.33 | 2.0 | Refer to DTC P0441 in the OBD DTC Summary Table for all monitoring values.SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
| 131 ($83) | P0441 | Purge Flow Monitor passive test. | 0.148 | 1 | Refer to DTC P0441 in the OBD DTC Summary Table for all monitoring values.SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
| 134 ($86) | P0441 | Purge Flow Monitor. | -10 or 0.035 | -0.35 or 10 | Refer to DTC P0441 in the OBD DTC Summary Table for all monitoring values.SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
-- If any of components or systems fail to meet the specified values, refer to "Diagnostic Mode 03 - Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure, refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.
End of Diagnosis.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.