Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Angle Sensor
Steering angle sensor -G85- is installed between steering wheel and steering column switch.
Removing and Installing
Refer to STEERING ANGLE SENSOR -G85-
-- Afterwards, basic setting of steering angle sensor must be performed.
-VAS 5051-, connecting and selecting functions Vehicle Diagnostic, Test and Information System VAS 5051, CONNECTING AND SELECTION FUNCTIONS .
From calendar week 22/2008, the steering angle sensor is located inside the steering gear on vehicles equipped with generation 3 electro-mechanical steering.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.