Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine data
2004 Volkswagen R32SECTION Engine data
| Engine code | BJS | ||
| Manufactured | 10.03 → | ||
| Emission values in accordance with | LEV2 Norm * See note | ||
| Cylinder arrangement | VR * See note | ||
| Cylinder angle | 15.0 ° | ||
| Displacement | ltr. | 3.2 | |
| Output | kW at 1/rpm | 177/6200 | |
| Torque | Nm at rpm | 320/3200 | |
| Bore | dia. mm | 84.0 | |
| Stroke | mm | 95.9 | |
| Compression ratio | 11.25 | ||
| RON | min. | 98 unleaded * See note | |
*LEV = Low Emission Vehicles
* VR = V-Arrangment in compact in-line design
* In exceptional circumstances min. 95 RON, however with reduced performance
| Engine code | BJS | ||
| Fuel injection, ignition | Motronic ME7.1.1 | ||
| Ignition sequence | 1-5-3-6-2-4 | ||
| Knock control | 2 knock sensors | ||
| Oxygen sensor regulation | 4 sensors | ||
| Self-Diagnosis | OBD ll | ||
| Catalytic converter | yes | ||
| Exhaust gas recirculation | no | ||
| Charging | no | ||
| Secondary air injection (AIR) system | yes | ||
| Electronic Power Control (EPC) | yes | ||
| Variable intake manifold | yes | ||
| Variable valve timing | yes * See note | ||
| Leak diagnosis system | yes | ||
* Two independently variable camshafts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.