Code Control Module (function 07)

Coding, initiating 

• Connect VAG1551 Scan Tool (ST), select operating mode 1 "Rapid data transfer", switch ignition on and enter address word 19 for "Gateway".

After control module identification and identification number of immobilizer are displayed:

• Press → button until "Select function XX" is shown in display.

Rapid data transfer HELP Select function XX

Indicated on display:

• Press buttons -0- and -7- to select "Code Control Module", function 07.

Rapid data transfer Q 07 - Code Control Module

Indicated on display: (example only)

• Press -Q- button to confirm input.

Code Control Module Enter code numbers XXXXX (0-32000)

Indicated on display: (example only)

• Determine code number using code table and enter.

Code table 

Control modules on powertrain CAN-Bus		Code number:
ABS		00002
Airbag		00004

The code numbers for the control modules installed in the vehicle that are connected to the powertrain databus must be added.

Example:

Airbag + ABS:

00004 + 00002 = 00006

6N0909901 Gateway K <-> CAN 0001 Coding 00006 WSC 00000

Indicated on display (example) :

• Press -Q- button to confirm input.

Rapid data transfer HELP Select function XX

Indicated on display: (example only)

End function:

• Press buttons -0- and -6- to select "End Output", function 06.

The tester returns to the "Select function" mode.