Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002PASSAT GLS, 4D SEDAN, 1.8 D, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTACCESSORIES CONTROL SYSTEMSRADIO, TELEPHONE, NAVIGATION ON BOARD DIAGNOSTIC (OBD)01 ON BOARD DIAGNOSTIC (OBD)MULTI-FUNCTION STEERING WHEEL > 12.01, ON BOARD DIAGNOSTIC (OBD)CODE CONTROL MODULE (FUNCTION 07)NOTES
2002 Volkswagen Passat GLS, 4D Sedan, 1.8 D, Standard
Code Control Module (function 07): Notes
2002 Volkswagen Passat GLS, 4D Sedan, 1.8 D, StandardSECTION Notes
Use this function to code the Multi-function Steering Wheel (MSW) electronics.
Coding
- Connect VAG 1551 Scan Tool (ST), input address word 16 "Steering wheel electronics"
| 1J0907487 Steering wheel electron.x28 → Coding 00008 WSC 00000 |
Indicated on display (example only):
NOTE:
Control module coding depends on the part number of the control module installed. Make note of the control module part number when displayed by the Scan Tool.
- Press → button
| Rapid data transfer HELP Select function XX |
Indicated on display (select function):
- Press buttons -0- and -7- to select "Code control module" function 07".
- Press -Q- button to confirm input.
- Indicated on display:
- Refer to control module part number noted earlier, and check/enter applicable code number from code tables. Refer to Code Tables .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.