SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002PASSAT GLS, 4D SEDAN, 1.8 D, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURES - IMPORTACURASYSTEM READINESS TEST CODESHO2S MONITOR CODE
2002 Volkswagen Passat GLS, 4D Sedan, 1.8 D, Automatic

HO2S Monitor Code

2002 Volkswagen Passat GLS, 4D Sedan, 1.8 D, AutomaticSECTION HO2S Monitor Code
NOTE: Once test is started DO NOT turn ignition switch off. When negative battery cable is disconnected, all readiness codes are cleared.

Ensure ambient temperature is 20-95°F (-7-35°C).

  1. Connect scan tool to DLC.
  2. Start engine and hold at 3000 RPM with no load (in park or neutral) until radiator fan comes on.
  3. Let engine idle for 5 seconds.
  4. Drive vehicle at steady speed between 50 and 62 MPH for about two minutes
  5. With A/T in "D" position, M/T in 5th gear, decelerate from 62 MPH by completely releasing throttle for 5 seconds.
  6. Bring vehicle to a stop. Leave engine running at idle speed. If engine is stalls or is shut off during this part of procedure, repeat procedure starting in step  4.
  7. Readiness code should now be set. Use scan tool to check readiness code.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.