Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002PASSAT GLS, 4D SEDAN, 1.8 D, AUTOMATICREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURES - IMPORTACURASYSTEM READINESS TEST CODESHO2S HEATER MONITOR CODE
2002 Volkswagen Passat GLS, 4D Sedan, 1.8 D, Automatic
HO2S Heater Monitor Code
2002 Volkswagen Passat GLS, 4D Sedan, 1.8 D, AutomaticSECTION HO2S Heater Monitor Code
NOTE:
Once test is started DO NOT turn ignition switch off. When negative battery cable is disconnected, all readiness codes are cleared.
- Connect scan tool to DLC.
- Start engine and let idle for 10 minutes.
- Readiness code should now be set. Use scan tool to check readiness code.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.