Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 97 (1.8L - GENERIC SCAN TOOL, ENGINE CODE(S): AWP, AWW, AWD (A4 PLATFORM))38 - AUTOMATIC TRANSMISSION - GEARS, HYDRAULIC CONTROLSTRANSMISSION CONTROL MODULE (TCM) J217TRANSMISSION CONTROL MODULE (TCM) J217 REPLACING, 4 SPD. AUTOMATIC TRANSMISSION 01M

2002 Volkswagen Golf GLS, 2.0 K, Standard

Transmission Control Module (TCM) J217 replacing, 4 Spd. Automatic Transmission 01M

2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Transmission Control Module (TCM) J217 replacing, 4 Spd. Automatic Transmission 01M

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for enabling/locking the Transmission Control Module (TCM) J217.
To perform adaptation of the anti-theft immobilizer. Refer to the Ebahn website.

Procedure

Check the identification of the previous Transmission Control Module (TCM) J217 as follows:

Connect the scan tool.
Switch the ignition on.
Select "Diagnostic mode 9: Vehicle information."
Select the "Test-ID 04: Calibration identification".

The Transmission Control Module (TCM) J217 identification will be displayed, e.g.: 09G27750 L 0301
End diagnosis and switch the ignition off.

Removal

Remove the wiper arms and wind cowl.

Fig 1: Releasing Multi-Pin Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect the electrical harness connector in the direction of the arrow.

Fig 2: Identifying TCM Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove the mounting bolts - arrows -

Installation

Installation is performed in the reverse order of removal. note the following:
Check the identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
Code the Transmission Control Module (TCM) J217.

Final procedures

Check the DTC memory.
If necessary, erase DTC memory of the Transmission Control Module (TCM) J217..
If the DTC memory was erased, generate readiness code.

End diagnosis

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.