SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 91 (2.8L & 3.2L - GENERIC SCAN TOOL, ENGINE CODE(S): AFP, BDF, BJS [A4 PLATFORM] (28 IGNITION/GLOW PLUG SYSTEM - ST GENERIC SCAN TOOL))ST GENERIC SCAN TOOLDIAGNOSTIC MODE, SELECTINGADDRESS WORD 33 - ON-BOARD DIAGNOSTIC (OBD)
2002 Volkswagen Golf GLS, 2.0 K, Standard

Address word 33 - On-Board Diagnostic (OBD)

2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Address word 33 - On-Board Diagnostic (OBD)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Function 

Under "address word 33 - On-Board Diagnostic (OBD)", various diagnostic modes for Engine Control Module (ECM) and Transmission Control Module -TCM- (in vehicles with automatic transmission) can be selected via diagnostic tester.

The following diagnostic modes monitor all components and systems which influence the emission quality.

NOTE:
  • Engine Control Module (ECM) reports with Module number 10 - Engine Electronics.
  • Transmission Control Module -TCM- (vehicles with automatic transmission) reports with Module number 1A - Transmission Electronics.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.