Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 85 (1.8L - ON BOARD DIAGNOSTIC (OBD), GENERIC SCAN TOOL - AWD, AWP, AWW)GENERIC SCAN TOOLSELECT DIAGNOSTIC FUNCTIONDIAGNOSTIC MODE 2: CHECKING OPERATING CONDITIONSPROCEDURE
2002 Volkswagen Golf GLS, 2.0 K, Standard
Diagnostic mode 2: Checking operating conditions: Procedure
2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Procedure
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen GTI, 2004 Volkswagen Jetta, and 2004 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Connect diagnostic tester, see CONNECT DIAGNOSTIC TESTER .
- Depending on the desired operating condition: switch on ignition
or Start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 2: Check operating conditions."
- Select the desired operating condition "PID XX".
NOTE:
The operating conditions are sorted by the PID (parameter-identifications).
DISPLAY OPERATING CONDITIONS SPECIFICATION
| PID | Display operating conditions |
|---|---|
| 03: | Condition of the fuel system |
| 04: | Calculated load condition value |
| 05: | Cooling fluid temperature |
| 06: | Short time gasoline -air ratio bank 1 |
| 07: | Gasoline-air ratio bank 1 |
| 12: | Engine rotations per minute (RPM) |
| 13: | Vehicle speed |
- End diagnosis and switch ignition off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.