Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
IPOD BASEPLATE -R192-, Troubleshooting
Special tools and workshop equipment required
- Hand-Held Multimeter V.A.G 1526C
- Connector Test Kit V.A.G 1594C
The iPod baseplate does not have OBD.
The voltage supply can be checked at the connector.
Test Conditions
- iPod OK, refer to the Operating Instructions.
- iPod RESET performed, refer to the Operating Instructions.
- Fuse OK.
- Radio/RNS no faults using Vehicle diagnostic tester.
Procedure
-- Remove the iPod baseplate. Refer to IPOD BASEPLATE -R192- .
-- Disconnect the connector under the iPod baseplate.
-- Turn on the radio/RNS
-- Measure the voltage between contacts 3 and 6 as well as between contacts 3 and 8 on the wiring harness connector using V.A.G 1526C and the cables from the V.A.G 1594C.
Specified value: approximately 12 V.
-- Turn off the radio/RNS.
Voltage values not OK:
-- Check the wire connection between the radio and the iPod baseplate according to the wiring diagram.
Voltage values OK:
-- Replace the iPod baseplate.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.