Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 100 (2.8L - FUEL INJECTION IGNITION, ENGINE CODE(S): AFP (A4 PLATFORM))28 IGNITION/GLOW PLUG SYSTEMIGNITION SYSTEM, SERVICINGIGNITION SYSTEM, GENERAL INFORMATION
2002 Volkswagen Golf GLS, 2.0 K, Standard
Ignition system, general information
2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Ignition system, general information
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Only the components which specifically relate to the ignition system are dealt with here. For the other components of the injection and ignition system → 24 Multiport Fuel Injection (MFI) .
- The Engine Control Module (ECM) is equipped with On Board Diagnostic (OBD).
- Components marked with an are checked via the On Board Diagnostic (OBD) → Diagnostic Trouble Code (DTC) memory, checking and erasing (scan tool functions 02 and 05) .
- For trouble-free operation of the electrical components, a voltage of at least 11.5 V is necessary.
- While making some repairs, it is possible that the control module will recognize a malfunction and store a DTC. Therefore, after completing all checks and repairs, check and erase DTC memory → Diagnostic Trouble Code (DTC) memory, checking and erasing (scan tool functions 02 and 05) .
- Safety precautions → Safety precautions .
- Test data, spark plugs → Technical data, spark plugs .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.