Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (STEERING (A3 PLATFORM))POWER STEERING, SERVICINGPOWER STEERING GEAR, REMOVING AND INSTALLINGNOTES
2002 Volkswagen Golf GLS, 2.0 K, Standard
Power steering gear, removing and installing: Notes
2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Notes
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Pay special attention to the following rules of cleanliness when working on the power steering.
- Thoroughly clean all connections and adjacent areas before disconnecting.
- Place parts that have been removed on a clean surface and cover.
- Do not use fluffy cloths.
- Carefully cover or seal opened components if the repairs cannot be completed immediately.
- Only install clean components.
- Only unpack replacement parts immediately prior to installation.
- Do not use parts which have been stored loose (e.g. in tool box).
- When the system is open do not work with compressed air or move the vehicle if it can be avoided.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.