SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2002GOLF GLS, 2.0 K, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSBODY ON BOARD DIAGNOSTIC (OBD) (A4 PLATFORM) [CONVENIENCE SYSTEM (VEHICLES WITH POWER WINDOWS), ON BOARD DIAGNOSTIC (OBD)]01 ON BOARD DIAGNOSTIC (OBD)CONVENIENCE SYSTEM (VEHICLES WITH POWER WINDOWS), ON BOARD DIAGNOSTIC (OBD)DISPLAY GROUP OVERVIEW, VEHICLES THROUGH 05.01EVALUATING DISPLAY GROUP NUMBER 012
2002 Volkswagen Golf GLS, 2.0 K, Standard

Evaluating display group number 012

2002 Volkswagen Golf GLS, 2.0 K, StandardSECTION Evaluating display group number 012
Display zone  Description  Display  Corrective action 
1 Check bus Bus OK.
Bus not OK.
  • Visual check of wiring
  • Check that connections of relevant current circuit are correctly connected and seated securely while simultaneously observing display
  • If the display does not change when operating, repair malfunction or replace relevant component
  • If no changes occur, separate all door main connectors and reconnect one after the other again
  • Observe measured value block
  • If display changes, replace relevant control module
  • Erase DTC memory
  • Perform functional check
  • Check DTC memory again
          Continued on next chart
Display zone  Description  Display  Corrective action 
2 Front equipment driver
driver and passenger
passenger
empty1)		 These display zones simply show the relevant vehicle equipment
  • For example, checks can be made to see which control modules are actively connected to the system and which are not
3 Rear equipment rl
rl and rr
rr
empty1)		  
4 Optional equipment memory
empty1)		  

1) Empty means in this case: Display zone is blank

Example: 

For DTC "Door control module (DCU), rear left not answering" can be directly seen if the DCU is connected.

For example, only "rr" is shown in display zone 3.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.