Convenience System Control Module, coding

• Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Convenience system, initiating On Board Diagnostic (OBD)  .

Indicated on display:

Rapid data transfer HELP Select function XX

• Press buttons -0- and -7- (with 07 the function "Code control module" is selected).

Indicated on display:

Rapid data transfer Q 07 Code control module

• Confirm entry with the -Q- button.

Indicated on display:

Code control module Q Enter code number XXXXX (0-32000)

• Enter code number according to table:

Address word	Code number
Vehicle equipment	2 doors	4 doors
46 Comfort Convenience
Electric windows, one door	00256	04096
46 Comfort Convenience
Electric windows, all doors	00257	04097
46 Comfort Convenience
Electric windows with seat memory, one door	00258	04098
46 Comfort Convenience
Electric windows with seat memory, all doors	00259	04099

Address word	Code number
Vehicle equipment	2 doors	4 doors
46 Comfort Convenience
Electric windows, one door	00064	00258
46 Comfort Convenience
Electric windows, all doors	00065	00259
46 Comfort Convenience
Electric windows with seat memory, one door	N/A	00258
46 Comfort Convenience
Electric windows with seat memory, all doors	N/A	00259

• Confirm entry with the -Q- button.

The control module identification number will be displayed with the appropriate index letter, the code number and the workshop code.

1J0959799J 03 Conv. cent. CU 0001 → Coding XXXXX WSC XXXXX

If the contents of the display are as shown then the coding is successful.

If the code number entered is not accepted by the control module, the previous coding will appear in the display:

Indicated on display:

1J0959799J 03 Conv. cent. CU 0001 → Coding XXXXX WSC XXXXX

In this case the control module has not been programmed with the relevant data for the vehicle. A check must then be completed to see if the correct control module for the vehicle has been installed (compare Part No. and letter index), or whether an incorrect code number has been entered.

• Repeat coding.

If the control module cannot be coded (correct control module, correct code number), the control module is malfunctioning.

Furthermore, at this point the door control module is called-up and checked.

End output:

• Press → button.

Indicated on display:

Rapid data transfer HELP Select function XX

• Press buttons -0- and -6- to end the output.

Indicated on display:

Rapid data transfer Q 06 End output

• Confirm entry with the -Q- button.

Indicated on display:

Rapid data transfer HELP Enter address word XX

• Switch off ignition.
• Disconnect connector to V.A.G 1551 scan tool.