Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2001CABRIO GLX (1V7) L4-2.0L (ABA)REPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER SWITCHSERVICE AND REPAIR
2001 Volkswagen Cabrio GLX (1V7) L4-2.0L (ABA)
Wiper Switch: Service and Repair
2001 Volkswagen Cabrio GLX (1V7) L4-2.0L (ABA)SECTION Service and Repair
WARNING: Special safety precautions and some different procedures apply to vehicles equipped with airbags. Air Bag Systems
CAUTION: Before working on the electrical system:
- Determine the correct coding for the anti-theft radio.
- Disconnect the battery Ground (GND) strap.
- Be sure the ignition is switched OFF (also applies when connecting the battery). Failure to do so may damage the Engine Control Module (ECM).
- Disconnecting the battery causes the basic setting of ECM to be erased. This may result in driveability problems.
Removing Turn Signal Switch -E2- and Windshield Wiper/Washer Switch -E22-:
1. Obtain audio coded anti-theft code, then disconnect battery ground cable.
2. Remove steering wheel as outlined under "Steering Wheel, Replace".
3. Remove lower and upper trim cover attaching screws, then trim covers, as necessary.
4. Remove attaching screws, then detach switch unit from steering column.
5. Disconnect multi-pin connectors, then remove switch unit.
6. Reverse procedure to install, noting the following:
a. Lubricate turn signal cancelling ring with multi-purpose grease.
b. Reset audio coded anti-theft system.
CAUTION: Before working on the electrical system:
- Determine the correct coding for the anti-theft radio.
- Disconnect the battery Ground (GND) strap.
- Be sure the ignition is switched OFF (also applies when connecting the battery). Failure to do so may damage the Engine Control Module (ECM).
- Disconnecting the battery causes the basic setting of ECM to be erased. This may result in driveability problems.
Removing Turn Signal Switch -E2- and Windshield Wiper/Washer Switch -E22-:
1. Obtain audio coded anti-theft code, then disconnect battery ground cable.
2. Remove steering wheel as outlined under "Steering Wheel, Replace".
3. Remove lower and upper trim cover attaching screws, then trim covers, as necessary.
4. Remove attaching screws, then detach switch unit from steering column.
5. Disconnect multi-pin connectors, then remove switch unit.
6. Reverse procedure to install, noting the following:
a. Lubricate turn signal cancelling ring with multi-purpose grease.
b. Reset audio coded anti-theft system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.