Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN2001CABRIO GLX (1V7) L4-2.0L (ABA)REPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESFROM 09/1994ERASE DTC MEMORY (FUNCTION 05)
2001 Volkswagen Cabrio GLX (1V7) L4-2.0L (ABA)
Erase DTC Memory (Function 05)
2001 Volkswagen Cabrio GLX (1V7) L4-2.0L (ABA)SECTION Erase DTC Memory (Function 05)
Erase DTC Memory (function 05)
- Scan Tool (ST) V.A.G 1551, connecting.
- Initiate On Board Diagnostic (OBD. On Board Diagnosis (OBD) For Airbag, Initiating
- Switch printer on via Print -button (indicator lamp in button illuminates).
Requirements
- Malfunction was repaired
- DTC memory was checked again
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press buttons - 0 - and - 5 - to select "Erase DTC Memory", function 05.
Indicated on display:
Rapid data transfer Q
05 - Erase DTC Memory
- Press Q button to confirm input.
Indicated on display:
Rapid data transfer -->
DTC Memory is erased.
- Press --> -button.
Indicated on display
Rapid data transfer HELP
Select function XX
NOTE:
- Test sequence is faulty if this message is displayed.
WARNING: DTC memory was not checked
- Follow test sequence exactly: first check DTC memory, then erase it.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.