SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999GTI (1J1) V6-2.8L (AFP)REPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSSERVICE AND REPAIRPROCEDURES
1999 Volkswagen GTI (1J1) V6-2.8L (AFP)

Procedures

1999 Volkswagen GTI (1J1) V6-2.8L (AFP)SECTION Procedures


Side Mounted Turn Signals, Removing And Installing

Removing:

CAUTION!

- Removal of turn signal lense/housing is only possible in one direction. The side of the housing equipped with retainer clip is not obvious in it's installed position. Use care when removing to prevent damage to retainer clip or housing.

- Switch off all electrical consumers, switch off ignition key and remove ignition key.






- Press turn signal with a suitable tool on the mounting position side -1- carefully in direction of arrow against the force of the spring clip -2- on the opposite side and lever out (protect paintwork surface with adhesive tape first if necessary).
- Pull rubber holder with push-fit bulb off bulb housing.
- Pull push-fit bulb (12 V/5 W) out of housing (do not turn).

Installing:

- Fit rubber holder with push-fit bulb onto bulb housing and insert into fender opening.
- Check side turn signal (bulb) function.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.