Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1999GTI (1J1) V6-2.8L (AFP)REPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSLIGHTING AND HORNSCOMBINATION SWITCH
1999 Volkswagen GTI (1J1) V6-2.8L (AFP)
Combination Switch
1999 Volkswagen GTI (1J1) V6-2.8L (AFP)SECTION Combination Switch
Switch for windshield wiper and washer system and multi-function indicator
A - Harness connector, 6-pin
1 - MFI call-up button - right
2 - MFI call-up button - left
3 - MFI call-up button - terminal 31
4 - MFI safe switch - Reset
5 - Windshield wiper intermittent circuit regulator - to automatic intermittent wash/wipe relay
6 - Windshield wiper intermittent circuit regulator - terminal 31
B - Harness connector, 8-pin
1 - Windshield wiper switch - terminal 53
2 - Windshield wiper switch - terminal 31
3 - Windshield wiper switch - terminal 53e
4 - Windshield wiper switch - terminal 53c
5 - Windshield wiper switch - rear window wiper
6 - Windshield wiper switch - terminal 53b
7 - Windshield wiper switch - intermittent operation
8 - Windshield wiper switch - terminal 53a
Switch for turn signals, high and low beam, flasher and parking light
C - Harness connector, 12 pin
1 - Switch for dimmer/flasher - terminal 30
2 - Switch for dimmer/flasher - terminal 30
3 - Turn signal switch - terminal L
4 - Vacant
5 - Turn signal switch - terminal 49a
6 - Horn plate - terminal 71
7 - Switch for dimmer/flasher - terminal 56
8 - Switch for dimmer/flasher - terminal 56b
9 - Vacant
10 - Vacant
11 - Turn signal - terminal R
12 - Switch for dimmer/flasher - terminal 56a
Switch for cruise control system
D - Harness connector, 10 pin
1 - Vacant
2 - Switch for CCS - On / Off
3 - Buttons for GRA - Set / Delay
4 - Switch for CCS - Reset / Resume saved speed / Accelerate
5 - Switch for CCS - Reset / Resume saved speed / Accelerate
6 - Switch for CCS - On / Off
7 - Switch for CCS
8 - Vacant
9 - Vacant
10 - Vacant
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.