Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLKSWAGEN1998EUROVAN V6-2792CC 2.8L (AES)REPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULESERVICE AND REPAIR
1998 Volkswagen Eurovan V6-2792cc 2.8L (AES)
Cruise Control Module: Service and Repair
1998 Volkswagen Eurovan V6-2792cc 2.8L (AES)SECTION Service and Repair
CCS Control Unit -J213-, Removing And Installing
- Remove glove compartment.
- Unbolt mounting plate with control unit -1- and relay -arrows-.
- Pull connector -2- off control unit -1-.
- Take out control unit with mounting plate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.