Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Pressure Regulator
The control pressure regulator (or warm-up regulator) controls fuel pressure to the top of the plunger in the fuel distributor. See Fig 1 .
During cold start operation, reduced pressure allows the plate to open farther with same air flow. This supplies more fuel to the cylinders to improve engine warm up, until normal operating temperature is reached. As the engine reaches operating temperature (or a pre-determined time elapses), the control pressure regulator increases control pressure, leaning the air/fuel mixture.
A bi-metallic strip in the control pressure regulator is heated by an electric coil. As it heats up, it gradually increases the control pressure. Poor electrical connections will cause warm-up function of the regulator to cease operation. Some regulators have an altitude-sensitive function that compensates for changes in barometric pressure.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.