Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Preparation For Testing
- All CIS systems are very sensitive to air leaks. Check condition of rubber boots, hoses, and gaskets. Other areas of leakage are injectors, cold start valve, and PCV system (filler cap and dipstick).
- Install a pressure gauge to perform fuel pressure tests. On all models, pressure gauge is installed between the control pressure regulator and the center fitting on fuel distributor. See Fig 1.
After installation, bleed pressure gauge by opening and closing valve several times.
- To operate fuel pump with engine not running, disconnect fuel pump relay from relay panel (VW, Porsche, Audi, Saab, Mercedes-Benz). Insert a jumper wire into sockets that correspond to terminals 30 and 87 on relay. See Fig 2.
- On Peugeot, remove steering wheel and lower left dash panel. Install switch and harness (8.0141P) to tachymetric relay connector, or jumper across terminals 30 and 87B. See Fig 2. On Volvo, Mercedes-Benz, and other models so equipped, disconnect safety switch connector on air flow sensor.
Saab shown, other models similar.
Directions given for moving sensor plate apply to engines where air flow lifts sensor plate UP. Reverse directions if servicing an engine where air flow pushes sensor plate DOWN.
- Operate fuel pump on Peugeot by depressing switch on harness. On all other models, turn ignition on. Place pressure gauge as low as possible in engine compartment, then open and close valve 5 times to bleed gauge. Place valve in open position and hang in convenient location. Turn pump off.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.