Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TR3 Models
Two adjustments may be made to the TR3 steering gear box with steering system in place. First adjustment is to preload steering shaft, and is accomplished by adding to, or taking from, shim pack located between end cover and steering box. When adjusting this shim pack, a slight amount of preload is permissible, however, in no circumstances must there be any end float. Next, rocker shaft of steering gear box may be adjusted by means of set screw and lock nut, located on top cover plate of gear box. Rocker shaft is adjusted correctly when steering wheel may be turned from lock to lock with a slight resistance at center of travel, which should correspond to straight ahead position of steering.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.