Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation [11/2018 - 02/2019]: Procedure
- INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Refer to INITIALIZATION [11/2018 - 08/2020]
- Install the 4 spark plugs to the cylinder head sub-assembly.
Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)
NOTE:If a spark plug has been struck or dropped, replace it.
- Install the 4 spark plugs to the cylinder head sub-assembly.
- INSTALL IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 2
- INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 58
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.