Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Components [02/2019 - 06/2020]
2020 Toyota RAV4 XLE, AWDSECTION Components [02/2019 - 06/2020]
WARNING: This page is about a different variant/trim than selected.
| *1 | BATTERY SERVICE HOLE COVER | *2 | SERVICE PLUG GRIP |
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | for AWD | *B | w/ NO. 2 INVERTER PROTECTOR |
| *1 | CONNECTOR COVER ASSEMBLY | *2 | ENGINE ROOM MAIN WIRE |
| *3 | NO. 2 INVERTER PROTECTOR | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | N.m (kgf/cm, ft.lbf): Specified torque |
| Callout | Description | Callout | Description |
| *1 | BATTERY SERVICE COVER BOARD | *2 | BENCH TYPE REAR SEAT CUSHION ASSEMBLY |
| *3 | NO. 2 BATTERY SERVICE COVER BOARD | *4 | NO. 3 BATTERY SERVICE COVER BOARD |
| *5 | REAR DOOR SCUFF PLATE LH | *6 | REAR DOOR SCUFF PLATE RH |
| *7 | REAR SEAT CUSHION LEG SUB-ASSEMBLY | *8 | REAR SEAT CUSHION LOCK HOOK |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | • | Non-reusable part |
| Callout | Description | Callout | Description |
| *A | for Short Type | *B | for Long Type |
| *1 | FRONT FENDER FRONT SPLASH SHIELD LH | *2 | FRONT FENDER FRONT SPLASH SHIELD RH |
| *3 | NO. 1 ENGINE UNDER COVER | *4 | NO. 2 ENGINE UNDER COVER ASSEMBLY |
| *a | Short Type Front Fender Front Splash Shield | *b | Long Type Front Fender Front Splash Shield |
| N.m (kgf/cm, ft.lbf): Specified torque | - | - |
| Callout | Description | Callout | Description |
| *1 | ENGINE UNDER COVER HEAT INSULATOR | *2 | FRONT CENTER FLOOR COVER |
| *3 | FRONT EXHAUST PIPE ASSEMBLY | *4 | FRONT FLOOR COVER LH |
| *5 | FRONT FLOOR COVER RH | *6 | GASKET |
| N.m (kgf/cm, ft.lbf): Specified torque | • | Non-reusable part |
| Callout | Description | Callout | Description |
| *1 | ENGINE SERVICE COVER CUSHION | *2 | FRONT LOWER NO. 1 FLOOR HEAT INSULATOR |
| *3 | FRONT NO. 1 FLOOR HEAT INSULATOR | *4 | FRONT NO. 2 FLOOR HEAT INSULATOR |
| *5 | NO. 2 ENGINE SERVICE COVER CUSHION | *6 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| N.m (kgf/cm, ft.lbf): Specified torque | - | - |
| Callout | Description | Callout | Description |
| *A | for AWD | *B | w/ NO. 1 FLOOR UNDER COVER |
| *1 | NO. 1 FLOOR UNDER COVER | - | - |
| N.m (kgf/cm, ft.lbf): Specified torque | - | - |
| Callout | Description | Callout | Description |
| *A | for 2WD | *B | for AWD |
| *1 | HV FLOOR UNDER WIRE | *2 | NO. 1 HV BATTERY COVER PANEL RH |
| *3 | BATTERY COVER LOCK STRIKER | *4 | ENGINE ROOM MAIN WIRE |
| *5 | NO. 1 TERMINAL CAP | *6 | NO. 4 RELAY BLOCK COVER |
| *7 | STUD CLAMP | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | N.m (kgf/cm, ft.lbf): Specified torque | ||
| • | Non-reusable part | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.