Inspection [11/2018 - ]: Procedure

2020 Toyota RAV4 XLE, AWDSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
  1. INSPECT HYBRID BATTERY TERMINAL BLOCKΒ 
    1. Measure the resistance according to the value(s) in the table below.
      GTY764144Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      Hybrid Battery Terminal Block Always Below 1 Ξ©

      If the result is not as specified, replace the hybrid battery terminal block.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.