Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection [02/2019 - ]: Procedure
2020 Toyota RAV4 XLE, AWDSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT IGNITION OR STARTER SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Ignition or Starter Switch Assembly)*b LOCK *c ACC *d ON *e START Standard Resistance
Tester Connection Condition Specified Condition Between all terminals LOCK 10 kΩ or higher 6 (ACC) - 7 (AM1) ACC Below 1 Ω 6 (ACC) - 7 (AM1) - 8 (IG1) ON Below 1 Ω 1 (AM2) - 2 (IG2) 5 (ST1) - 7 (AM1) - 8 (IG1) START Below 1 Ω 1 (AM2) - 2 (IG2) - 4 (ST2)
- Measure the resistance according to the value(s) in the table below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.