Parts Location [11/2018 - ]: Illustration

2020 Toyota RAV4 XLE, AWDSECTION Illustration
WARNING: This page is about a different variant/trim than selected.
Fig 1: Wireless Door Lock Control System (For Hv Model, With Smart Key System) Replacement Components (1 Of 3) [11/2018 - ]
GTY914468Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*1 FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH *2 FRONT DOOR WITH MOTOR LOCK ASSEMBLY RH
*3 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *4 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH
*5 REAR DOOR LOCK WITH MOTOR ASSEMBLY LH *6 REAR DOOR LOCK WITH MOTOR ASSEMBLY RH
*7 REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *8 REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH


Fig 1: Wireless Door Lock Control System (For Hv Model, With Smart Key System) Replacement Components (2 Of 3) [11/2018 - ]
GTY881546Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*1 HEADLIGHT ASSEMBLY RH
- TURN SIGNAL LIGHT
*2 HEADLIGHT ASSEMBLY LH
- TURN SIGNAL LIGHT
*3 SIDE TURN SIGNAL LIGHT ASSEMBLY RH *4 SIDE TURN SIGNAL LIGHT ASSEMBLY LH
*5 REAR COMBINATION LIGHT ASSEMBLY RH
- TURN SIGNAL LIGHT
*6 REAR COMBINATION LIGHT ASSEMBLY LH
- TURN SIGNAL LIGHT
*7 DOOR CONTROL RECEIVER *8 WIRELESS DOOR LOCK BUZZER


Fig 1: Wireless Door Lock Control System (For Hv Model, With Smart Key System) Replacement Components (3 Of 3) [11/2018 - ]
GTY879916Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*1 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *2 COMBINATION METER ASSEMBLY
*3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- AM2 FUSE
- ECU-IG1 NO. 4 FUSE
- ECU-ACC FUSE
- ECU-B NO. 3 FUSE
*4 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
*5 DLC3 - -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.