SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 36 (SMART KEY SYSTEM (FOR START, HV) - DIAGNOSTICS - INTRODUCTION (1 OF 2))SMART KEY SYSTEM (FOR START FUNCTION, HV MODEL)PARTS LOCATION [02/2019 - 12/2021]ILLUSTRATION
2020 Toyota RAV4 XLE, AWD

Parts Location [02/2019 - 12/2021]: Illustration

2020 Toyota RAV4 XLE, AWDSECTION Illustration
WARNING: This page is about a different variant/trim than selected.
Fig 1: Smart Key System (For Start Function, Hv Model) Replacement Components (1 Of 3) [02/2019 - 12/2021]
GTY930925Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*1 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
- SKID CONTROL ECU ASSEMBLY		 - -


Fig 1: Smart Key System (For Start Function, Hv Model) Replacement Components (2 Of 3) [02/2019 - 12/2021]
GTY870853Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*A w/ Rear Door Entry - -
*1 FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
  1. - ELECTRICAL KEY ANTENNA
  2. - LOCK SENSOR
  3. - UNLOCK SENSOR
 *2 FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH
  1. - ELECTRICAL KEY ANTENNA
  2. - LOCK SENSOR
  3. - UNLOCK SENSOR
*3 REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
  1. - ELECTRICAL KEY ANTENNA
  2. - LOCK SENSOR
  3. - UNLOCK SENSOR
 *4 REAR DOOR OUTSIDE HANDLE ASSEMBLY RH
  1. - ELECTRICAL KEY ANTENNA
  2. - LOCK SENSOR
  3. - UNLOCK SENSOR
*5 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (FRONT FLOOR) *6 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (REAR FLOOR)
*7 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (INSIDE LUGGAGE COMPARTMENT) *8 ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE COMPARTMENT)
*9 NO. 1 ENGINE ROOM RELAY BLOCK
  1. - ECU-IG2 NO. 1 FUSE
  2. - ECU-IG2 NO. 2 FUSE
  3. - IG2 NO. 1 RELAY
 - -


Fig 1: Smart Key System (For Start Function, Hv Model) Replacement Components (3 Of 3) [02/2019 - 12/2021]
GTY883971Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
*1 POWER SWITCH *2 STOP LIGHT SWITCH ASSEMBLY
*3 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *4 COMBINATION METER ASSEMBLY
- SECURITY INDICATOR LIGHT
*5 STEERING LOCK ECU (STEERING LOCK ACTUATOR WITH ECU ASSEMBLY) *6 DLC3
*7 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *8 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. - STOP FUSE
  2. - WASHER FUSE
  3. - AM2 FUSE
  4. - ECU-IG1 NO. 1 FUSE
  5. - STRG LOCK FUSE
  6. - P/OUTLET NO. 1 FUSE
  7. - SFT LOCK-ACC FUSE
  8. - ECU-ACC FUSE
  9. - ECU-IG2 NO. 3 FUSE
  10. - ECU-DCC NO. 2 FUSE
  11. - ECU-B NO. 1 FUSE
  12. - ECU-ACC RELAY
  13. - IG1 NO. 1 RELAY
  14. - IG1 NO. 2 RELAY
  15. - IG2 NO. 2 RELAY
*9 SHIFT LOCK CONTROL UNIT ASSEMBLY *10 ID CODE BOX (IMMOBILISER CODE ECU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.