Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 36 (SMART KEY SYSTEM (FOR START, HV) - DIAGNOSTICS - INTRODUCTION (1 OF 2))SMART KEY SYSTEM (FOR START FUNCTION, HV MODEL)HOW TO PROCEED WITH TROUBLESHOOTING [12/2021 - 10/2023]CAUTION / NOTICE / HINT
2020 Toyota RAV4 XLE, AWD
Caution / Notice / Hint
2020 Toyota RAV4 XLE, AWDSECTION Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
HINT:
- Replace parts related to the wireless door lock control system and smart key system according to the inspection procedure.
- If the wireless door lock control system and smart key system does not operate, first check the customize item and make sure that the wireless door lock control system and smart key system is not turned off.
Refer to CUSTOMIZE PARAMETERS [11/2018 - 10/2022] , or refer to CUSTOMIZE PARAMETERS [10/2022 - ]
- The wireless door lock control system and smart key system primarily uses the following systems.
- Power door lock control system
- Wireless door lock control system
- Smart Key system (for Entry Function)
- Smart Key system (for Start Function)
- : Immobiliser function
- When 2 or more keys are registered, perform the inspection with another key.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.