Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal [10/2023 - ]: Procedure
2020 Toyota RAV4 XLE, AWDSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE DECK BOARD ASSEMBLY
Refer to REMOVAL [10/2023 - ]
- REMOVE REAR NO. 2 FLOOR BOARD
Refer to REMOVAL [10/2023 - ]
- REMOVE BATTERY HOLE COVER
Refer to REMOVAL [10/2023 - ]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to REMOVAL [10/2023 - ]
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 20
- REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
- Disconnect the cam timing control motor with EDU assembly connector.
- Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.NOTE:
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
- Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.
- Disconnect the cam timing control motor with EDU assembly connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.