Parts Location [11/2018 - 02/2019]: Illustration

2020 Toyota RAV4 XLE, AWDSECTION Illustration
WARNING: This page is about a different variant/trim than selected.
Fig 1: Smart Key System (For Entry Function, Hv Model) Replacement Components (1 Of 4) [11/2018 - 02/2019]
GTY882163Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*A w/o Power Back Door System - -
*1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *2 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH
*3 FRONT DOOR WITH MOTOR LOCK ASSEMBLY LH *4 FRONT DOOR WITH MOTOR LOCK ASSEMBLY RH
*5 REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *6 REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH
*7 REAR DOOR WITH MOTOR LOCK ASSEMBLY LH *8 REAR DOOR WITH MOTOR LOCK ASSEMBLY RH
*9 BACK DOOR OPENER SWITCH ASSEMBLY *10 BACK DOOR LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY


Fig 1: Smart Key System (For Entry Function, Hv Model) Replacement Components (2 Of 4) [11/2018 - 02/2019]
GTY931425Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*1 FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
  1. - ELECTRICAL KEY ANTENNA
  2. - LOCK SENSOR
  3. - UNLOCK SENSOR
*2 FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH
  1. - ELECTRICAL KEY ANTENNA
  2. - LOCK SENSOR
  3. - UNLOCK SENSOR
*3 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (FRONT FLOOR) *4 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (REAR FLOOR)
*5 NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (INSIDE LUGGAGE COMPARTMENT) *6 ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE COMPARTMENT)
*7 DOOR CONTROL RECEIVER *8 WIRELESS DOOR LOCK BUZZER


Fig 1: Smart Key System (For Entry Function, Hv Model) Replacement Components (3 Of 4) [11/2018 - 02/2019]
GTY868012Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*A w/ Power Back Door System *B w/ Hands Free Power Back Door
*1 MULTIPLEX NETWORK DOOR ECU *2 BACK DOOR LOCK WITH COURTESY LIGHT SWITCH ASSEMBLY
*3 KICK DOOR CONTROL SENSOR - -


Fig 1: Smart Key System (For Entry Function, Hv Model) Replacement Components (4 Of 4) [11/2018 - 02/2019]
GTY876706Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
*1 POWER SWITCH *2 COMBINATION METER ASSEMBLY
*3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. - AM2 FUSE
  2. - ECU-DCC NO. 2 FUSE
  3. - ECU-IG1 NO. 4 FUSE
*4 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
*5 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *6 DLC3
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.