Monitor Description

2020 Toyota RAV4 XLE, AWDSECTION Monitor Description
WARNING: This page is about a different variant/trim than selected.

The ECM monitors the signals received from the No. 1 throttle position sensor. As the ECM monitors the VTA1 signal of the No. 1 throttle position sensor, if these signals do not correlate, a DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P060E-49 Internal Control Module Throttle Position Performance Internal Electronic Failure Either of the following conditions is met (1 trip detection logic):
  • ECM main CPU malfunction.
  • ECM sub CPU malfunction.
ECM Comes on DTC stored SAE Code: P060E
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.