SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 130 (ENGINE CONTROL SYSTEM (A25A-FXS) (W/O CANISTER PUMP MODULE) - DIAGNOSTIC CODES (3 OF 4))SFI SYSTEM (W/O CANISTER PUMP MODULE)DTC P0607-47: CONTROL MODULE PERFORMANCE BANK 1 WATCHDOG/SAFETY MCU FAILURE; DTC P0607-87: CONTROL MODULE PERFORMANCE BANK 1 MISSING MESSAGE [11/2018 - 08/2020]PROCEDURE
2020 Toyota RAV4 XLE, AWD

DTC P0607-47: Control Module Performance Bank 1 Watchdog/Safety MCU Failure; DTC P0607-87: Control Module Performance Bank 1 Missing Message [11/2018 - 08/2020]: Procedure

2020 Toyota RAV4 XLE, AWDSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
  1. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

    5. Turn the power switch off.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. READ OUTPUT DTC (DTC P0607-47 OR P0607-87) 
    1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
    2. Connect the cable to the negative (-) auxiliary battery terminal.
    3. Connect the Techstream to the DLC3.
    4. Turn the power switch on (IG).
    5. Turn the Techstream on.
    6. Wait 1 second or more.
    7. Enter the following menus: Powertrain / Engine / Trouble Codes.
    8. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output A
      DTC P0607-47 or P0607-87 is output B

    Result: 

    A 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [11/2018 - 08/2020] 

    Result: 

    B 

    REPLACE ECM. Refer to  REMOVAL [11/2018 - 02/2019]  , or refer to  REMOVAL [02/2019 - 08/2020] 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.