SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSSTOP AND START SYSTEM - SERVICE INFORMATIONVACUUM SENSOR ASSEMBLYREMOVAL [11/2018 - ]PROCEDURE
2020 Toyota RAV4 XLE, AWD

Removal [11/2018 - ]: Procedure

2020 Toyota RAV4 XLE, AWDSECTION Procedure
  1. REMOVE VACUUM SENSOR ASSEMBLY 
    1. Disconnect the connector from the vacuum sensor assembly.
    2. Remove the vacuum sensor assembly from the brake booster assembly.
      GTY928450Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE VACUUM SENSOR GROMMET 
    1. Remove the vacuum sensor grommet from the brake booster assembly.
      GTY848444Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.