Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Vehicle Inspection [11/2018 - ]: Procedure
2020 Toyota RAV4 XLE, AWDSECTION Procedure
- INSPECT VACUUM SENSOR ASSEMBLY
- Connect the Techstream to the DLC3.
- Start the engine.
- Turn the ignition switch off.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Stop and Start / Data List / Brake Boost Pressure.
Powertrain > Stop and Start > Data List
Tester Display Brake Boost Pressure - Compare the "Brake Boost Pressure" values before and after the brake pedal was depressed 5 times.
Standard
Internal pressure changes by 20 kPa (0.2 kgf/cm2 , 2.9 psi) or more.
HINT:
If the result is not as specified, replace the vacuum sensor assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.