Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Components [11/2018 - 11/2024]
2020 Toyota RAV4 XLE, AWDSECTION Components [11/2018 - 11/2024]
Fig 1: Rear Cross Traffic Alert Buzzer Replacement Components With Torque Specifications [11/2018 - 11/2024] (1 Of 2)
| Callout | Description | Callout | Description |
| *A | for Gasoline Model | *B | for HV Model |
| *1 | BENCH TYPE REAR SEAT CUSHION ASSEMBLY | *2 | CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH |
| *3 | NO. 3 BATTERY SERVICE COVER BOARD | *4 | REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| *5 | REAR DOOR SCUFF PLATE LH | *6 | REAR SEAT CUSHION LOCK HOOK |
| *7 | REAR SEAT SIDE GARNISH LH | *8 | REAR SEATBACK ASSEMBLY LH |
| *9 | REAR SEATBACK HINGE SUB-ASSEMBLY LH | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping":N.m (kgf/cm, ft.lbf) | • | Non-reusable part |
| *A | w/ Tonneau Cover | - | - |
| *1 | BLIND SPOT MONITOR BUZZER | *2 | DECK BOARD ASSEMBLY |
| *3 | DECK TRIM SIDE PANEL ASSEMBLY LH | *4 | INNER ROOF SIDE GARNISH ASSEMBLY LH |
| *5 | LUGGAGE HOLD BELT STRIKER ASSEMBLY | *6 | REAR FLOOR FINISH PLATE |
| *7 | REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE | *8 | REAR NO. 3 FLOOR BOARD |
| *9 | TETHER ANCHOR BRACKET SET | *10 | TONNEAU COVER ASSEMBLY |
| • | Non-reusable part | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.