Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2020RAV4 XLE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSDYNAMIC RADAR CRUISE CONTROL SYSTEM (EXCEPT HV) - DIAGNOSTIC CODES & CIRCUIT TESTSDYNAMIC RADAR CRUISE CONTROL SYSTEM (FOR GASOLINE MODEL)STEERING PAD SWITCH CIRCUIT [08/2020 - 12/2021]DESCRIPTION
2020 Toyota RAV4 XLE, AWD
Steering Pad Switch Circuit [08/2020 - 12/2021]: Description
2020 Toyota RAV4 XLE, AWDSECTION Description
- The steering pad switch assembly outputs the dynamic cruise control on/off signal and various control signals to the ECM.
- The ECM controls the dynamic cruise control system according to the signals received from the steering pad switch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.