Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Components [11/2015 - ]
2018 Toyota Prius Two EcoSECTION Components [11/2015 - ]
Fig 1: Power Window Regulator Motor (Front Door) Replacement Components With Torque Specifications (1 Of 2)
| Callout | Description | Callout | Description |
| *A | for Driver Side | *B | for Front Passenger Side |
| *1 | COURTESY LIGHT ASSEMBLY | *2 | FRONT ARMREST ASSEMBLY |
| *3 | FRONT DOOR INNER GLASS WEATHERSTRIP | *4 | FRONT DOOR INSIDE HANDLE BEZEL PLUG |
| *5 | FRONT DOOR TRIM BOARD SUB-ASSEMBLY | *6 | FRONT DOOR VENT SEAL |
| *7 | MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL | *8 | POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL |
| *9 | FRONT DOOR WEATHERSTRIP | - | - |
Fig 2: Power Window Regulator Motor (Front Door) Replacement Components With Torque Specifications (2 Of 2)
| Callout | Description | Callout | Description |
| *1 | FRONT DOOR GLASS SUB-ASSEMBLY | *2 | FRONT DOOR SERVICE HOLE COVER |
| *3 | FRONT DOOR WINDOW REGULATOR ASSEMBLY | *4 | POWER WINDOW REGULATOR MOTOR ASSEMBLY |
| *5 | HOLE PLUG | *6 | FRONT DOOR WEATHERSTRIP CLIP |
| *7 | FRONT DOOR NO. 2 SERVICE HOLE COVER | - | - |
| N.m (kgf.cm, ft./lbf): Specified torque | MP grease |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.