Removal [11/2015 - ]: Procedure

2018 Toyota Prius Two EcoSECTION Procedure
  1. REMOVE REAR BUMPER ASSEMBLY 

    Refer to REMOVAL [11/2015 - 12/2018] , or refer to REMOVAL [12/2018 - ]

  2. REMOVE ELECTRICAL KEY ANTENNA 
    1. Disconnect the connector.
      GTY597939Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Remove the nut.
    3. Disengage the guide to remove the electrical key antenna as shown in the illustration.
      NOTE:

      Be careful when removing the electrical key antenna. If the electrical key antenna is dropped, replace it with a new one.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.