Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Panel Switches do not Function [11/2015 - 08/2019]: Procedure
- CHECK PANEL SWITCH
- Check for foreign matter around the switches that might prevent operation.
OK
No foreign matter is found.
Result
Proceed to OK NG
Result:
NG
REMOVE FOREIGN MATTER
Result:
OK
See step 2
- Check for foreign matter around the switches that might prevent operation.
- CHECK PANEL & STEERING SWITCH (OPERATION CHECK)
- Enter the "Panel & Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.
Refer to OPERATION CHECK [11/2015 - 08/2019]
- Operate the abnormal switch and check if the switch status is correctly displayed.
OK
The switch status is correctly displayed as operated.
Result
Proceed to OK NG
Result:
OK
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to REMOVAL [11/2015 - 08/2019]
Result:
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [11/2015 - 08/2019]
- Enter the "Panel & Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.