Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2018PRIUS TWO ECOREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEDYNAMIC RADAR CRUISE CONTROL SYSTEM - DIAGNOSTIC CODES & CIRCUIT TESTSDYNAMIC RADAR CRUISE CONTROL SYSTEMDTC C1A10: FRONT RADAR SENSOR [11/2015 - 07/2020]CAUTION / NOTICE / HINT
2018 Toyota Prius Two Eco
Caution / Notice / Hint
2018 Toyota Prius Two EcoSECTION Caution / Notice / Hint
NOTE:
- When replacing the driving support ECU assembly, make sure to replace it with a new one. If a device which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle, and as a result, a DTC may be stored.
- When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Refer to ADJUSTMENT [11/2015 - 12/2018] , or refer to ADJUSTMENT [12/2018 - 07/2020]
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.