Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection [06/2016 - ]: Procedure
- INSPECT FUEL INJECTOR ASSEMBLY NOTE:
This inspection aims is to inspect the fuel injectors for opens or shorts, because the fuel injectors of this vehicle are of a high-pressure type and cannot be inspected for fuel injection volume.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 1.9 Ω TEXT IN ILLUSTRATION*a Component without harness connected
(Fuel Injector Assembly)If the result is not as specified, replace the fuel injector assembly.
- Measure the resistance according to the value(s) in the table below.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.