SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSGENERATOR (SERVICE INFORMATION)GENERATORREASSEMBLY [06/2016 - ]PROCEDURE
2018 Toyota 86 GT, Standard Trans

Reassembly [06/2016 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure
  1. INSTALL IC REGULATOR 
    1. Install the IC Regulator with the 3 bolts.
      GTY726522Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Bolt A 

      Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf) 

      Bolt B 

      Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  2. INSTALL BRUSH ASSEMBLY 
    1. Install the brush assembly with the 2 bolts.

      Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf) 

  3. INSTALL REAR COVER 
    1. Install the rear cover.
  4. INSTALL TERMINAL B 
    1. Install the terminal B with the nut.

      Torque: 8.9 N*m (91 kgf*cm, 79 in.*lbf) 

    2. Install the cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.