Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEM (EXT) (SERVICE INFORMATION)REAR LIGHT ASSEMBLYDISASSEMBLY [06/2016 - ]PROCEDURE

2018 Toyota 86 GT, Standard Trans

Disassembly [06/2016 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure

REMOVE BACK-UP LIGHT BULB

Turn the back-up light socket and wire with the back-up light bulb in the direction indicated by the arrow shown in the illustration and remove them as a unit.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the back-up light bulb from the rear light socket and wire.
HINT:

Use the same procedure for the RH and LH sides.

REMOVE BACK-UP LIGHT SOCKET AND WIRE

Disengage the 2 clamps to remove the back-up light socket and wire.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.