SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEM (EXT) (SERVICE INFORMATION)REAR COMBINATION LIGHT ASSEMBLYREMOVAL [06/2016 - ]PROCEDURE
2018 Toyota 86 GT, Standard Trans

Removal [06/2016 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure
  1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT 
  2. REMOVE REAR FLOOR FINISH PLATE 
    1. Using a clip remover, remove the 3 clips.
      GTY392500Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 4 claws to remove the rear floor finish plate.
  3. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH 

    Refer to PROCEDURE - Step 3

  4. REMOVE REAR COMBINATION LIGHT ASSEMBLY 
    1. Disconnect the connector.
      GTY701853Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Grommet
    2. Disengage the 2 grommets and disconnect the wire harness.
    3. Remove the 4 nuts.
      GTY706871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disengage the guide to remove the rear combination light assembly.
      GTY388762Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.