Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEM (EXT) (SERVICE INFORMATION)REAR COMBINATION LIGHT ASSEMBLYDISASSEMBLY [06/2016 - ]PROCEDURE

2018 Toyota 86 GT, Standard Trans

Disassembly [06/2016 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure

REMOVE REAR COMBINATION LIGHT GASKET LH

Remove the rear combination light gasket LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Be sure to remove all the traces of the old rear combination light gasket from the rear combination light lens and body LH.
Do not reuse the removed packing. Be sure to install a new rear combination light gasket to prevent water ingress.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.