Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEM (EXT) (SERVICE INFORMATION)HEIGHT CONTROL SENSORREMOVAL [06/2016 - ]PROCEDURE

2018 Toyota 86 GT, Standard Trans

Removal [06/2016 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure

REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 3 nuts.
Disengage the guide and remove the rear height control sensor sub-assembly LH.
NOTE:
Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.