SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA201886 GT, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEM (EXT) (SERVICE INFORMATION)HEADLIGHT ASSEMBLYREMOVAL [06/2016 - ]PROCEDURE
2018 Toyota 86 GT, Standard Trans

Removal [06/2016 - ]: Procedure

2018 Toyota 86 GT, Standard TransSECTION Procedure
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT BUMPER COVER 

    (Refer to REMOVAL [06/2016 - ] ).

  3. REMOVE FRONT BUMPER SIDE SUPPORT LH 
    1. Disengage the 2 clamps to disconnect the wire harness.
      GTY471558Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt A.
      GTY734034Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 3 bolts B and the front bumper side support LH.
  4. REMOVE HEADLIGHT ASSEMBLY 
    1. Disconnect each connector.
    2. Remove the clip.
      GTY471559Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the bolt.
    4. Disengage the claw to remove the headlight assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.